The 240 D-WALL Dehumidifier is a vertical, built-in refrigeration-cycle unit. The unit is able to perform isothermal dehumidification during the summer period, meaning it can dehumidify the air and supply it back into the room at a temperature close to the one at which it was extracted. More specifically, dehumidification occurs through contact between humid air and the cold surface of the unit’s heat exchanger, where condensate droplets form; these are then collected and discharged through the dedicated drain. For proper dehumidification, the unit must be connected to a chilled-water circuit and to the condensate drainage system.
The main components of the unit are the refrigeration cycle (evaporator, condenser, hermetic compressor and capillary tube), a hydronic heat exchanger, and a fan to move the air flow. The unit is equipped with a filter installed on the front grille.
The unit features an on-board display to facilitate start-up and maintenance procedures. The unit is designed to be controlled via Eurotherm’s SmartComfort 365 controller (recommended) via Modbus RTU RS485, or via digital enable/consent signals.
Nominal air flow rate: 240 m3/h
Condensation capacity (recirculation): 25.0 l/day
Nominal entering water temperature: 15°C
Wall-mounting frame and lacquered wooden grille are accessories (not included)
Dimensions and measurements
In the heart of the Castelli Romani, we are at work at Villa Nancy, a prestigious property built in the 1950s and formerly the residence of Alcide De Gasperi.
A small construction site in the province of Pavia, involving the energy refit of a single-family house through the installation of the Leonardo 3.5 radiant ceiling heating and cooling system.
Eurotherm radiant systems safer and guaranteed without time limit by ITAS insurance. Eurotherm now offers a full lifetime warranty original parts and breakdown warranty on its entire radiant systems range.